Author |
Message |
support |
Posted: Wed May 15, 2013 9:05 am Post subject: |
|
sure it is ... with only water there will happen as good as nothing |
|
|
adeel.rahman |
Posted: Wed May 15, 2013 5:23 am Post subject: |
|
The problem was actually the stainless steel cleaner I was using. I only cleaned it with water yesterday and today it worked flawlessly.
Is it a bad idea to only use water to clean the stainless steel electrodes? |
|
|
support |
|
|
adeel.rahman |
Posted: Mon May 13, 2013 11:23 pm Post subject: |
|
You can see the knob is maxed out yet the current is at 13 mA... extremely frustrating (doing feet).
|
|
|
adeel.rahman |
Posted: Mon May 13, 2013 11:07 pm Post subject: Doesn't start |
|
I'm having a lot of trouble lately. The device doesn't start sometimes. If I clean it thoroughly again it MAY work, but sometimes still doesn't.
I clean it every time after I finish using it. I use the stainless steel electrodes, tried using stainless steel cleaner.
It just says: "Set the therapy current" and stays there.
Also is it normal that my machine goes up to 26 mA? I would have guessed the maximum was 25. |
|
|